Embroidered Lace Has A Wide Variety Of Patterns, And The Embroidery Is Exquisite And Beautiful

Embroidery lace, which is embroidery, is a traditional handicraft in our country, and it occupies an important position in the national traditional handicrafts.

Embroidered lace. It has been gradually developed by the handicrafts of countries all over the world in a long historical period. Embroidered lace can be divided into machine-embroidered lace and hand-embroidered lace. Machine-embroidered lace is a large-scale production developed on the basis of hand-embroidered lace. Lace varieties.

The machine-embroidered lace is embroidered by an automatic embroidery machine, that is, the striped pattern is obtained on the gray fabric under the control of the jacquard mechanism, and the production efficiency is high. Fabrics of various raw materials can be used as machine-embroidered grey fabrics, but thin fabrics are mostly used, especially cotton and rayon fabrics have the best effect. There are two types of small-machine embroidery and large-machine embroidery, and large-machine embroidery is the most common. The effective embroidery length of the large machine embroidery lace is 13.7 meters (15 yards). Embroidering on the 13.5 meters long fabric can be made into full-width embroidery or cut into lace strips. According to different requirements, different embroidery base fabrics can be used to produce different types of lace, such as water-soluble lace, mesh lace, pure cotton edge, polyester cotton edge and various tulle sliver laces. The pattern can be adjusted freely according to needs. 2bw.Megx machine embroidered water-soluble lace is a large category of embroidery lace. It uses water-soluble non-woven fabric as the base fabric and viscose filament as the embroidery thread. It is rusted on the base fabric by a computer embroidery machine, and then heated with hot water. The treatment melts the water-soluble non-woven base fabric, leaving a three-dimensional lace. It can be made into strips and special-shaped flower patterns according to the requirements of use. The latter is widely used in the decoration of clothing collars and bras. The embroidery machine is equipped with a multi-color automatic color selection and color-changing device, which can be used for single-color machine embroidery or multi-color machine embroidery. Generally, the longest flower back can be up to 650 mm, and the width of the lace is more than 10 mm. After the machine is off the machine, it will be finished after the final treatment is opened. The machine embroidered lace has a variety of patterns, the embroidery is exquisite and beautiful, uniform and uniform, the image is lifelike, full of artistic and three-dimensional feeling. At present, the production areas of machine embroidery in my country are mainly concentrated in Shandong, Guangdong and Xiaoshao, Zhejiang. Machine embroidery has high production efficiency and low cost, and has been popularized by most manufacturers.